Compatible with MERCEDES W204 C Class C250 C300 C350 C63 Door Wing Mirror Housing Turn Signal Indicator Side LED Light Blub (Left)

My cars right side mirror lights started filling up with water from rain and eventually one of the two LED lights died. My car kept giving my fast flashing and dash warnings about replacing the light that was super annoying. I purchased these as a replacement since the original Mercedes parts were almost double the price.The light is not an exact fit. However it does work. Firstly it does not come with the original rubber gasket so you have to take the original al gasket and peel it off and replace it. Secondly the four tabs do not clip into the mirror assembly perfectly. Thankfully there are two screws to hold it in place. Finally from the photo, the led chip itself is not flush inside the housing. Small issues from non exact fit or moldings. However it is cheaper and it does work and solve my problem. Hence I can’t say it’s a poor product.Replacing one of these is pretty easy. It took about 20 min. Knowing how to do it now I could probably do it in 10.1. Pull the mirror out. Use the mirror controls to move the mirror to an extreme and use a small flat head screwdriver to pry apart one of the tabs so it’s easier to get the mirror out without cracking the glass. Be very careful about cracking the glass.2. There are 3 torx screws to remove.3. There are 3 tab rectangle holes that you need a flat head screwdriver to pry apart. This lets you to pull out the black molding.4. There are 2 white tabs you can use your fingers to pull open and then gently pull the top mirror housing up and off.5. From here you can access the signal assembly itself. It’s pretty obvious from here out. Just remove the two torx screws and the tabs including the tabs that hold the plug. Pull off the rubber gasket and put it on the replacement signal assembly. Install in reverse order. Enjoy.

One of the plastic guide tabs was a little short and the housing wouldn't snap on like the OEM one, but once I attached the screws it held fine. Also the original has a seal that you should transfer onto the replacement to prevent leaks. You may have to trim the seal because they stretch when you remove the OEM housing.

Model/Size fits perfectly. Plug in connection it is not compatible with the original. Had to cut both wires (From the mirror plug and from turn signal) and weld them together. Also and very important!!! Wire colors are changed. Red goes with black and viceversa. (Positive with negative) Other wise it wont turn on. Other than that all good.

Well made looked oem it was a bit of a pain as this was the first time I had replaced one of these.

Llegó muy bien!

Fit great and and works great!!

My car

Excelente caída perfecta en el vehículo, sustituye el original sin problemas.

Great replacement on a 2008 C180. Easy enough to fit you will need torx screwdriver(t10).

I managed to fit this wing mirror indicator light in less than 10 minutes after watching a YouTube Video. This part was an excellent fit and exactly like the old Mercedes one which came off the car. Excellent!

We had ours stolen, so need a replacement was a perfect fit, thank you.

Fitted good and works, but fault light display on dash remains, had to add a resistor into circuit to fix

Ok